JUHUAN waterproof aerosol canned polyurethane PU foam spray sealant in construction

JUHUAN one component spray polyurethane foam is uesd preferable for insulation and insrallation,such as bonding ,sound and heat insulation,sealing,filling up crack and gap.

Purpose:

- Filling the space between the partition walls, floor and ceiling tiles;

- Filling the space between the wall panels and the box of a building;

- For sealing holes for wiring pipes and wires through a building structure elements;

- For the installation of window and door frames;

- Seal the space between the openings;

- Precipitation thresholds, stairs, and other elements of wood;

- Filling the space around chimneys and skylights.

NOT zapenivat confined spaces, devoid of air.

Features:

- Rapid solidification (under the influence of atmospheric moisture);

- Good acoustic and thermal insulation;

- Harmless to the ozone layer;

- Good to fill space;

- Good adhesion to wood, concrete, brick, steel, aluminum, glass and other materials;

- There is no adhesion to polyethylene film, Teflon, silicone, bitumen, Teflon PP and PE.

Mode of application:

- Clean the surface from grease stains, dust and dirt, at negative temperatures from ice and frost, at positive air temperatures the surface should be moistened with water to increase adhesion and improve the foam polymerization. Before applying the foam cylinder should be shaken vigorously. This is necessary for good mixing components. The optimum temperature of the cylinder + 20 * C. Before use, the balloon stored at room temperature of + 15C + 20 * C for at least 12 hours. Heating of the balloon over + 35 * C can lead to deterioration of foam. Peremorozhennuyu or not recommended to use superheated foam;

- Screw the plastic tube on the valve;

- Put in place a valve, by clicking on it;

- While the cylinder valve to keep down;

- The installation of door frames used stabilizing the crossbar;

- across hour (depending on the section of the fiber, temperature and humidity) to cut off excess hardened foam;

- Cut surface should be protected with silicone;

- A day foam can be plastered, painted, drilled, cut and paste it on any material;

- With topical foam must be protected from UV radiation;

- The vertical joints to fill from the bottom up.

Shelf life:

Cylinder stored upright in the primary package 12 months at + 5 * C + 25 * C.

Transport temperature:

-15 * C to + 35 * C.

Specifications

Temperature when using:

Security measures:

While working with the foam need to use protective gloves and work clothes, avoid contact with eyes. The container is under pressure, and therefore it is not allowed to damage, expose to temperatures above + 50 * C.

Keep away from children!